Subject: Re: Help with soft edges in Digital Image 9
Thanks Mary. I was hoping I had missed them placing the feature somewhere
else in the program.
I used to save after every little step for just these issues. I then got to
where I was doing more saving and less working :). So I went to saving at
each "junction". I guess I'll be going back to more saving ;).
> I know I used to live by using the softedges tool. I now use DI10 and it
> seems to take too much away from the outside. I now use the transparency
> brush to trim up the outside of a cutout, it takes quite a while, but well
> worth the effort if you have the time.
> I never tried to use a negative number, but the tool is wonderful for making
> a fake beveled edge!
> Yes once you close the project even saved in png, you can't go back and
> change it. The best thing would have been to make a copy of the cutout
> before you did anything to it, so you could start at the beginning if you
> needed to. But don't feel bad, I never save when I should either, sometimes
> it makes for more work.
> Proud To Use Picture It!
> > Hello,
> > In previous versions of Picture It, as long as the cutout existed in the
> > stack, you could use a negative number in the soft edges dialog box and
> > revert the soft edges setting back to "original". How is the same feat
> > accomplished in DI9? It does not allow negative numbers in the soft edges
> > dialog box.
> > I closed the session and cannot undo the soft edges. The cutout remains
> > in
> > the stack when I opened the png file back up in a later editing session,
> > but
> > now I no longer want soft edges. Is there any steps to remove the soft
> > edges
> > on the cutout without having to create a completely new cutout from the
> > original photograph?
View All Messages in microsoft.public.digitalimaging
Help with soft edges in Digital Image 9 =>Re: Help with soft edges in Digital Image 9 =>
Copyright © 2006 WatermarkFactory.com. All Rights Reserved.